Other Chassis for Lukyanov THoS

Tutorial for Lukyanov THoS (2023) Master Chassis

This hilt had a very limited space for the chassis, which doesn't mean we couldn't design some nice metal Master Chassis for it.

Concept

Other Parts Details

Magnets:
– 32 x 2mmx1mm NeoDymium Magnets

Introduction

  • Disclaimer

    GOTH-3Designs cannot be held responsible for any mistakes made by DIYers during their install. You must have a good understanding of what you’re doing, of the components used and the safety measures associated to them. Always wear protective gear when working on install (gloves, eye protection, …), GOTH-3Designs cannot be held responsible in case of accident.

  • Note #1

    Always use the smallest wires to make your install easier. There can be big differences between one wire type and another for the same AWG specs. PTFE Wires with the smallest OD are recommended such as those sold at The Saber Armory. A good wire management is also required, routing wires properly helps a lot saving space.

  • Note #2

    These instructions will not cover how to wire the soundboard, make sure to learn how to by reading the manual. We have also typical soundboards wiring available in the Padawan Tutorials. Always test your install along the way! Verifying that everything works after important steps is better than having to dismount everything because something wasn’t wired properly.

  • Note #3

    3D printed parts can have very slight accuracy variations. In some rare cases, some sanding or hole deburring can be required. Additionally, metal parts can arrive a bit bent, but are normally easy to bend back into shape. Consult the FAQ if you encounter issues with parts that cannot be solved easily.

Demo Video by KR-Sabers

Quick Install Guide

  • Install the Positive and Negative battery tabs.

    Install the Kill switch.

    Add the cover, and the kill switch cap.

    Install the speaker

    Glue the magnets on the chassis and 2 covers.

    Install the soundboard

    Slide in and glue the chassis cover

    Install the NPXL+ Switches PCB

    The removable chassis is ready


    For the top chassis, the part contain the NPXL PCB holder and 2 switch caps. They are to be gently cut away using a sharp knife.

    The rest of the install can be followed on the ECO Chassis PDF guide

    ECO Chassis PDF instructionDownload