Here are the install guides for KR Apprentice OWK1 ECO and ECO-CC Chassis.

KR-Sabers Apprentice OWK1 ECO Chassis

Introduction

  • Disclaimer

    GOTH-3Designs cannot be held responsible for any mistakes made by DIYers during their install. You must have a good understanding of what you’re doing, of the components used and the safety measures associated to them. Always wear protective gear when working on install (gloves, eye protection, …), GOTH-3Designs cannot be held responsible in case of accident.

  • Note #1

    Always use the smallest wires to make your install easier. There can be big differences between one wire type and another for the same AWG specs. PTFE Wires with the smallest OD are recommended such as those sold at The Saber Armory. A good wire management is also required, routing wires properly helps a lot saving space.

  • Note #2

    These instructions will not cover how to wire the soundboard, make sure to learn how to by reading the manual. We have also typical soundboards wiring available in the Padawan Tutorials. Always test your install along the way! Verifying that everything works after important steps is better than having to dismount everything because something wasn’t wired properly.

ECO Chassis and ECO-CC Chassis

  • The ECO, ECO-CC are installed the same way.
    ECO chassis wouldn’t need the magnets as it doesn’t use the CC add-ons.

    It is a pretty straight forward install, the only particularity / difficulty is linked to the hilt structure: the 2 chassis are installed separately, then inserted into to hilt body from the top and bottom, where wires will be joined in the middle (then hidden under the soundboard.

    Note that KR OWK1 and OWK2 are basically using the same setup and install process (while the parts are slightly different and not compatible one another).

    Battery Chassis

    Wire and install the speaker, and battery tabs (all components are secured using E6000 glue or equivalent).

    Then add the kill switch
     

    ECO-CC additonal steps:
    Wire and insert / glue the nano pixel in its slot. The pixel needs to be flush inside the slot. (the positive wire can go directly to the battery tab)

    And finally, glue in the 4 magents.

    Sounboard chassis

    Wire and install the Soundboard, swithces and NPXL connector.

    (optional) two 2020 short pixel strips can be added for extra effect on these flat surfaces

    ECO-CC additional step:
    And last, glue the 3 magnets
     

    Crystal Chamber Parts – ECO-CC only

    Glue the 8 magnets (making sure to respect polarity with the ones glued on the battery chassis parts).

    Insert and glue the crystal in its slot.

    Glue the 2 magnets that match the crystal holder part, and the 3 magnets that match the soundboard chassis.

    Now the part can be added as shown, and removed when needing to access the soundboard.