Shapeways Shop Section ⇒ C7 – Korbanth
Prices: Depends on the material and Shapeways current rates – add the part into the cart to estimate final cost
Install Level: Beginner
=> Part 1 Style 1 CFX: 89sabers-dooku-chassis-part1-style1-cfx
=> Part 1 Style 2 Proffie: 89sabers-dooku-chassis-part1-style1-proffie
=> Part 2: 89sabers-dooku-chassis-part2
3- DIY empty hilts:
⇒ Available on Korbanth website
4- Electronic components and blades:
Saber electronic components are basically more or less similar from one saber to another. You’ll need a main Led, a Battery, a recharge port, one or two switches, a soundboard, accent leds, a speaker and wires. Then the blade is the last part of your saber, they are usually made from PolyCarbonate tubes + tip.
You can find most of what you’ll need at The Saber Armory. Some components can also be found at The Saber Bay on Etsy. Local electronic shops or online stores like Digikey are also a good source.
⇒ Soundboard, ProffieBoard or CFX (Verso is also possible with the CFX to Verso adapter)
⇒ Battery, 18650 battery.
⇒ Main Led, Tri-Cree XPE-2 or Neopixel.
⇒ Switches, tactile switches
⇒ Speaker, 24mm bass speaker
⇒ Wires, PTFE wires available at The Saber Armory
⇒ Heat shrink tubing, to protect your solder joints.
Work in progress
Back to top
(step by step)
– These instructions will details the install procedure as much as possible. GOTH-3Designs cannot be held responsible for any mistakes made by DIYers.
– Always wear protective gear when working on install (gloves, eye protection, …), GOTH-3Designs cannot be held responsible in case of accident.
Use small wires to make your install easier
=> for Tri-cree install 30awg for main wires and 32awg for accent leds and switches are highly recommended
=> for Neopixel PTFE 24awg for main wires (battery and led strip + and -), and 32awg for accent leds and switches are highly recommended