Shapeways Shop Section ⇒ C9 – Watto’s junkyard
=> Part1 Main Chassis – includes switches plunger box and NPX Pogo-pin PCB holder.
CFX – tusken-slayer-chassis-cfx
Proffie – tusken-slayer-chassis-proffie
=> Part2 Covers – tusken-slayer-chassis-part2
=> Part3 Oled screen cover – tusken-slayer-chassis-part3
=> Part4 CC insert 1 – tusken-slayer-chassis-part4
=> Part5 CC cover – tusken-slayer-chassis-part5
=> Part6 Crystal – tusken-slayer-chassis-part6
ECO Chassis – wattos-junkyard-tusken-slayer-fdm-eco-chassis
PIY Files – wattos-junkyard-tusken-slayer-fdm-chassis-stl-file
2- DIY empty hilts:
⇒ Contact Watto’s Junkyard
3- Electronic components and blades:
Saber electronic components are basically more or less similar from one saber to another. You’ll need a main Led, a Battery, a recharge port, one or two switches, a soundboard, accent leds, a speaker and wires. Then the blade is the last part of your saber, they are usually made from PolyCarbonate tubes + tip.
You can find most of what you’ll need at The Saber Armory. Some components can also be found at The Saber Bay on Etsy. Local electronic shops or online stores like Digikey are also a good source.
⇒ Soundboard, ProffieBoard, Plecter Labs CFX (or other like Verso or GH3 using the CFX adapter)
⇒ Battery, 18650 removable battery. Battery holder integrated to the chassis using keystones battery contacts.
⇒ Kill switch, high amp
⇒ Main Led, Tri-Cree XPE-2 or Neopixel
⇒ Heatsink, included with the hilt or Neopixel pogo-pin holder
⇒ Switches, tactile switches
⇒ Speaker, 24mm speaker
⇒ Heat shrink tubing, to protect your solder joints.
⇒ 7/8″ OD blade for the main blade.
Back to top
(step by step)
– These instructions will details the install procedure as much as possible. GOTH-3Designs cannot be held responsible for any mistakes made by DIYers.
– Always wear protective gear when working on install (gloves, eye protection, …), GOTH-3Designs cannot be held responsible in case of accident.
WORK IN PROGRESS