– Return to MPP2.0 Chassis Line-Up –

Parts Details:

1- Hilt:

 Available on Korbanth

2- 3D printed Chassis parts:

All-in-1 chassis for straightforward install. Can hold all the soundboards, a 28mm speaker (bass or premium) and a 18650 battery (can also hold a 2×18500 pack for a 7.4v setup – only using premium speaker). The recharge port pins have to be cut short in order for the port to fit properly. There is a slot for an on/off switch, a kill key is also included with on/off feature. There is also a slot for a RICE port through Micro-JST.

SITH Apprentice All.In.One Chassis

3- Electronic components and blades:

Saber electronic components are basically more or less similar from one saber to another. You’ll need a main Led, a Battery, a recharge port, one or two switches, a soundboard, accent leds, a speaker and wires. Then the blade is the last part of your saber, they are usually made from PolyCarbonate tubes + tip.

You can search these parts with the following suppliers: Solo’s Hold, The Saber ArmoryElegant WeaponsJQ-Sabers

Soundboard, the “heart” of our sabers is the Soundboard, here are the 2 major Soundboard producers:
Plecter Labs – from the entry level Nano Biscotte to the high end Crystal Focus.
Naigon Elelctronic Creations – from the entry level Spark 2 to the high end I2.
Battery, 18650 battery for 3.7v or 2×16340 for 7.4v.
⇒ Recharge Port, 2.1mm port is used on this chassis (kill key included in the chassis kit).
 Battery charger, according to the battery voltage used.
 Main Led, Tri-Cree XPE-2 recommended
 Heatsink for 7/8″ blade holder
 Switches, main switch is included with the hilt. An Aux switch can be added (clamp switch holder required).
 On / Off Switch, an optional on/off switch can also be installed (Ex: Digikey).
 Speaker, 28mm Speaker, either premium or bass
 Accent Leds, 5mm led for the Crystal Chamber recommended (if RGB, read your soundboard manual to select between common anode or common cathode led), 3mm leds for the others.
 Wires, 30awg wires are recommended on most our 3D Printed chassis. We are buying them from this eBay seller.
 Heat shrink tubing, to protect your joints.
 RICE port 
– a RICE port can be added with a micro jst port. Ex on ebay.
 7/8″ OD Blades only.

 


 

MULTIBOARDS ADAPTIVE CHASSIS

On the Sith Apprentice Chassis, install the soundboard with the SD card on top, facing the pommel.

 

About the Kill Key. It is recommended to sand a bit the side of the kill key “on/off” slot, in order to make them more round and to turn better in the recharge port. (as a reminder, this slot allow to start / stop the saber without removing the kill key).

Recharge port wiring reminder:

 


Take a look at the Sith Master chassis build instructions, the apprentice chassis has the same structure without the crystal chamber.

Loading...
Facebook Messenger for Wordpress