– Return to Luke V2 Chassis Line-Up –

Parts Details:

1- ROTJ Luke V2 Hilt:

 Contact Solo’s Hold

2- 3D printed Chassis parts:

Nano Biscotte (Plastic – Recommended Black) –

For 28mm premium speaker, NB, 18650 and recharge port (on/off kill key included)
www.shapeways.com/product/8TT482YSM/v2-03-1-nb3-padawan-chassis-all-in-1

3- Electronic components and blades:

Saber electronic components are basically more or less similar from one saber to another. You’ll need a main Led, a Battery, a recharge port, one or two switches, a soundboard, accent leds, a speaker and wires. Then the blade is the last part of your saber, they are usually made from PolyCarbonate tubes + tip.

You can search these parts with the following suppliers: Solo’s Hold, The Saber ArmoryElegant WeaponsJQ-Sabers

Soundboard, the “heart” of our sabers is the Soundboard, here are the 2 major Soundboard producers:
Plecter Labs – from the entry level Nano Biscotte
Battery, 18650 battery for 3.7v
⇒ Recharge Port, 2.1mm port is used on this chassis (kill key included in the chassis kit).
 Battery charger
 Main Led, Tri-Cree XPE-2
 Switches, are included with the hilt.
 Speaker, 28mm Speaker flat premium only
 Accent Leds, 5mm led or 3mm leds can be added to the chassis.
 Wires, 30awg wires are recommended on most our 3D Printed chassis. We are buying them from this eBay seller.
 Heat shrink tubing, to protect your joints.
 7/8″ OD Blades only.

 


 

About the Kill Key. It is recommended to sand a bit the side of the kill key “on/off” slot, in order to make them more round and to turn better in the recharge port. (as a reminder, this slot allow to start / stop the saber without removing the kill key).

Recharge port wiring reminder:

Loading...
Facebook Messenger for Wordpress