Index:

=> Parts Details
=> Demo
=> Quick Install Guides


Parts Details:

1- 3D printed Chassis parts:

Shapeways Shop Section ⇒ C7 – Korbanth

Custom Chassis Fallen V2

Prices: Depends on the material and Shapeways current rates – add the part into the cart to estimate final cost
Install Level: Beginner
Variant 1 – For single hilt setup only (doesn’t work for staff). Removable battery slot, kill switch, 28mm bass speaker.
=> Chassis CFX: 89sabers-fallen-v2-var1-cfx
=> Chassis Proffie: 89sabers-fallen-v2-var1-proffie

Variant 2 – For staff setup. 21700 battery, 1.3mm recharge port, kill switch, 28mm bass speaker:
=> Chassis CFX:
=> Chassis Proffie

Custom Chassis Fallen V1

Prices: Depends on the material and Shapeways current rates – add the part into the cart to estimate final cost
Install Level: Beginner
Variant 1 – 18650 battery, 2.1mm recharge port, 28mm bass speaker
=> Chassis CFX: korbanth-fallen-var1-cfx
=> Chassis Proffie: korbanth-fallen-var1-proffie

Variant 2 – Removable battery slot, kill switch, 28mm bass speaker.
=> Chassis CFX: korbanth-fallen-var2-cfx
=> Chassis Proffie: korbanth-fallen-var2-proffie

3- DIY empty hilts:

 Available on Korbanth website

4- Electronic components and blades:
Saber electronic components are basically more or less similar from one saber to another. You’ll need a main Led, a Battery, a recharge port, one or two switches, a soundboard, accent leds, a speaker and wires. Then the blade is the last part of your saber, they are usually made from PolyCarbonate tubes + tip.
You can find most of what you’ll need at The Saber Armory. Some components can also be found at The Saber Bay on Etsy. Local electronic shops or online stores like Digikey are also a good source.
Soundboard, ProffieBoard or CFX (Verso is also possible with the CFX to Verso adapter)
Battery, 18650 battery.
Var1 for pre-wired battery and recharge port
Var2 for removable Keepower and kill switch. The chassis take the battery contacts available at The Saber Armory
 Main Led, Tri-Cree XPE-2 or Neopixel.
 Heatsink, 1″ heatsink or 1″ Pogo-pin PCB holder
 Switches, provided with the hilt
 Speaker, 28mm bass speaker
 Wires, PTFE wires available at The Saber Armory
 Heat shrink tubing, to protect your solder joints.
 1″ OD blade or 7/8″ OD blade (with 1″ adapter) for the main blade.

 


Demo:

Work in progress

Back to top

 


Quick Install Guide: 

Back to top
(step by step)

Disclainer:
– These instructions will details the install procedure as much as possible. GOTH-3Designs cannot be held responsible for any mistakes made by DIYers.
– Always wear protective gear when working on install (gloves, eye protection, …), GOTH-3Designs cannot be held responsible in case of accident.

Use small wires to make your install easier
=> for Tri-cree install 30awg for main wires and 32awg  for accent leds and switches are highly recommended
=> for Neopixel PTFE 24awg for main wires (battery and led strip + and -), and 32awg  for accent leds and switches are highly recommended

WORK IN PROGRESS

.

Back to top

Loading...
Facebook Messenger for Wordpress